Take the 2-minute tour ×
Geographic Information Systems Stack Exchange is a question and answer site for cartographers, geographers and GIS professionals. It's 100% free, no registration required.

This question continues story on link What's the syntax for an AttributeFilter in FME?.

Now, how can I test attribute value if there are more than one value and proceed it to the Clipper (uses as a multiple clippers)? Use some looping method?

In xml file is for example

So there can be maybe only one or can be many of them.

I tried and Tester output is only one value (last of possible values, in my example above Tester output is only areaID=1253).

Tnx,

share|improve this question

3 Answers 3

Most simple way is do an OR test with your tester. Set the test criteria to "OR" And then set a test for each attribute value For example: OR areaID=1253 areaID=1254 areaID=1255 areaID=1304 etc

share|improve this answer
    
This is what I know. I would like to do this without specify a specific value. Let imagine that value can be any number...In that case, how to do what I wanted? –  Z77 Dec 7 '11 at 12:40
    
If you just want to test if it is a number (rather than a string) then the AttributeClassifier might help. –  Mark Ireland Dec 8 '11 at 17:31

Composite Tests. (using the Tester Transformer)

Up until now, Testers have been resticted to a single test, for example an AND (Clause 1 AND Clause 2) or an OR (Clause 1 OR Clause 2), so that multiple clauses required multiple transformers.

enter image description here

Credit to Mark Ireland (Safe Software) and GIS SE member.

Source: http://evangelism.safe.com/fmeevangelist70/

share|improve this answer
    
I do not get it, unfortunaly. In Tester parameter you have to write exactly how many rtest clauses you r going to have. But what If you do not know If there will be just one value of an atribute or there will be more? In XML file where those value of attribute are, sometimes can be just one, and sometimes can be more ..I hope someone understand what I have to do?! Tnx. –  Z77 Dec 8 '11 at 7:41

Ok. I did it. So, attribute with multiple values I have defined as list in xfmap fil. After that by use of ListExploder in front of FeatureMerger, and than FeatureMerger itself connected to Tester I got postiv result as needed. Use of FeatureMerger is neccessry and just than can we perform testing. Why is that, it is still unknown to me?!...But that's solution for what i need. I hope this can help someone.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.