I'm going bananas trying to geocode addresses into a NAD1983.
I have ArcMap 10.1 and I'm using the default address locator (North American 10.0 from arcgis online). No matter how low I set the sensitivity, it gives me "There was an error trying to process this table" when I specifically choose NAD1983. If I allow it to create the X,Y coordinates in WGS1984, then I get coordinates...BUT my other coordinates (I'm going to measure distance/proximity) are in NAD1983.
Any suggestions? I can't figure out how to change them from WGS1984 to NAD1983 when they're in a layer, although I have changed the data frame successfully it seems...
Any guidance is very appreciated!