0
votes
0answers
15 views

Why don't my service area polygons follow my network?

I have found a few similar questions, but no good answers, so here goes another Service area question: I'm working on creating a walking distance layer from Parks, and have a road network set up with ...
1
vote
0answers
39 views

Can someone explain me how to do the layout of routes in ArcMap?

Can someone explain me how to do the layout of routes in ArcMap? I have a shape of points with garbage containers and want to do the route of each truck but don't know how. I've tried with the network ...
0
votes
0answers
103 views

Using Matlab to build adjacency matrix from Arcmap OD Matrix table

I was trying to use the function Network Analyst in Arcgis to generate the network to display the small world phenomenon, so i have to transport the shapefile (which contains originalID ...
0
votes
1answer
75 views

Network Dataset — can't solve route

I've built out numerous network datasets before, so I'm confused as to why I'm getting this error. I've built out a polyline file for the sidewalks in my community. Warning: No route from location ...
0
votes
0answers
42 views

Network Analysis: How to restrict certain road types and allow them to be traversable at intersections

I am faced with a problem for an assignment. I have tried restricting roads by using a restriction attribute with the following pre-logic script code with value = restricted restricted = false if ...
4
votes
0answers
80 views

Multimodal network v.s. single mode network [closed]

I created a multimodal network with rail, bus, and pedestrian network, and generated a 15 min service area (blue in the attached figure). I also created a single mode network with only pedestrian ...
0
votes
0answers
33 views

Errors in Output of Vehicle Routing Problem

I have 19 orders (stores), 3 depots (warehouses) and 3 routes (trucks) per each depot i.e. total 9 routes. When I ran the Network Analyst solver, I could only see the map of 8 routes. There were 3 ...
4
votes
1answer
637 views

How to create fixed length (and width) buffer around a polyline in ArcMap 10?

Could someone please help me? I would need to create 100 buffers (500m x 1km) along a stream polylines. I know how to do it by using shortest distance but the buffers should follow the curves of the ...
1
vote
0answers
290 views

trying to find areas within a certain driving distance along a road network WITHOUT a specific destination

I was hoping somebody might be able to help me out with this. I'm trying to use Arcmap 10.1 to find all the areas along a road network (a county roads layer in this case) that are a certain driving ...
1
vote
1answer
77 views

Does multimodal network need a physical intersection between a point (terminal) and a line (rail or road)?

I have created a network dataset with rail, road, and intermodal terminals and set up the connectivity so that you can only travel in-between the two at the terminals. Terminals realistically can be ...
6
votes
0answers
118 views

Symbolizing route data [duplicate]

I'm working on a project that routes various modes of transport to one location (a school) in Arc Map 10. I have about 400 routes, so there is a significant amount of overlap as they near the school. ...