1
vote
1answer
49 views

QGIS Slope Classification Issues

I am very new to QGIS for the primary purpose of creating a slopes layer so we know where slopes are above 15% or 20% or whatever we finally decide. I have used our DEM to create a slope geotif and ...
0
votes
0answers
56 views

DEM/DSM from contour lines and slopes

I want to create a DEM with as much detail as possible. The problem is, that the area contains several (manmade) slopes. I got contour lines and lines that mark the location of the slopes, but no ...
1
vote
1answer
124 views

QGIS DEM (Terrain models) Mode Slope creates wrong data [duplicate]

I have a DEM raster file downloaded from the USGS site. The file can be downloaded here. I am trying to create a slope raster in percent with the DEM tool in QGIS. The GDAL command is the following: ...
0
votes
0answers
78 views

Estimating sunlight hours from slope, aspect, and latitude

I'd like to estimate annual sun hours (or insolation, or solar radiation) for 4 points, 1 each on the four sides of the summit of a hypothetical flat-sided mountain. I have slope and aspect for each ...
0
votes
0answers
39 views

qgis - slope from DEM - errors due to projection and oversimplified 'z factor' [duplicate]

I'm trying to generate a slope raster from a DEM raster. It seems there is a pretty significant error due to the 'z-factor' option. I'm fairly new to this, but some other posts and responses ...
0
votes
1answer
49 views

Change slopes derived from DEM

I have a DEM for a region over which I want to simulate an ecological process. I would like to run several simulations for the same region but I want to alter the topography for the simulations. ...
2
votes
1answer
156 views

qgis2 slope analysis from NED data gives crazy histogram

I'm attempting a simple slope analysis in QGIS2 using the plugin at Raster -> Terrain Analysis -> Slope. The slope output layer has a very strange histogram, basically spikes at 0 and at 89.9098 with ...
5
votes
2answers
79 views

How to automate creation of toe of slope from DEM?

I was looking for an automated process to "identify" the toe of a slope from a DEM and ran across this ESRI thread and technique: I am at Step 7 but have no idea how this is accomplished. I get it is ...
2
votes
1answer
191 views

GTOPO30 Slope analysis in ArcGIS 10.1 [duplicate]

Using surface - slope analysis tool box. All values for the slope calculation are in between 80 and 89. There are no values below 80. What am I doing wrong?
0
votes
0answers
72 views

3D Polyline by Slope on Surface

I wish to project (continue/extend/whatever) a polyline upslope following a specified gradient along a DEM surface. Is there any way of doing this?
3
votes
1answer
133 views

Compute global DEM topographic indices and compromise projections

I would like to compute global topographic indices based on SRTM elevation data. These indices are computed along river/channel networks extracted from a DEM and are a functions of both local slope ...
3
votes
1answer
78 views

What function should I use to assess the degree of elevational change (rocky cliffs etc.) of a DEM?

I have a DEM of my research area and I want to assess how the topography/elevation changes. I am specifically looking to see what areas may be good suitable bat-roosting habitat so I am trying to ...