# Tagged Questions

For questions regarding the increments used in measuring values.

11k views

### Understanding QGIS buffer tool units?

I have been trying to figure this out for a couple weeks now and have had no luck getting the buffer tool to accept anything but degrees as units of measure. I have found lots of stuff saying the ...
3k views

### How to get \$length in meters in QGIS?

I read a lot of posts concerning that subject, nevertheless I cannot solve to problem of getting \$length in the field calculator in meters rather than in decimal degress in QGIS. The CRS of original ...
6k views

### Calculate distance in km to nearest points (given in lat/long) using ArcGIS DEsktop and/or R?

I have two point datasets in ArcGIS, both of which are given in WGS84 lat/lon co-ordinates and the points are spread across the whole world. I would like to find the nearest point in Dataset A to each ...
4k views

### What's the Workflow for buffering in meters/km using WGS84 layers?

I'm a little bit new to GIS, so bear with me a minute.... I'm using QGIS 1.7.4-Wroclaw and working with an SHP layer in WGS84. I want to buffer out to a certain number of kilometers from this layer ...
457 views

### Adjusting Z Units on a DEM

I am learning how to use ArcHydro and attempting to change the Z Units because I get a warning message saying the Spatial Reference Doesn't Match. The DEM was in Meters, and I adjusted the Z Unit to ...
2k views

### What is the unit the shapely length attribute?

I'm doing a very simple calculation of the length of a polyline using shapely: from shapely.geometry import LineString ... xy_list = [map(float,e) for e in xy_intm] line = LineString(xy_list) s = '%...
1k views

### Dimensional analysis/conversion problem: Map scale to image resolution (dpi)

Given a map scale of 1:17,200 and a raster whose cell size is 6 inches, what resolution (dots per inch) should I choose when exporting the map to an image in order to maintain the raster's native ...
8k views

### What are the units of the calculated area from a raster in decimal degree

I'm trying to calculate area for a raster file which contains 2 layers (0 for unsuitable habitat and 1 for suitable). It's been calculated successfully but I don't know what is the unit of the ...
545 views

### How to specify coordinate reference system (CRS) for scalebar that is different to project CRS?

Is it possible to specify a coordinate reference system (CRS) for the scalebar that is different to the project CRS? For example, my project CRS uses geographic coordinates (lat/long), the reason ...
2k views

### How do I know the vertical/horizontal units of my DEM? I'm creating a slope using gdaldem

I'm using gdaldem to create a slope map. I can apply a scale. The default is 1. The notes say: Ratio of vertical units to horizontal. If horizontal unit of source DEM is degrees (e.g WGS84 ...