Calculating Cut & Fill volume using ArcGIS Desktop? [closed]

I work with ArcMap 10.1.

There is a proposed area for building a dam. I'm just trying to calculate the approximate volume of dam in different elevations.

I created a raster of area and also other several rasters with different fixed elevations (50, 75,100 ...) and tried to calculate cut and fill volume through this order. But after calculation, when I open the attribute table the numbers don't make any sense. I attached the picture of table.

I have these questions:

1. Is this even a right way that I've chosen to calculate volume of a reservoir? If it is not how can I calculate it?
2. How can I find out what is the unit of numbers that were given in attributes table (cubic meter?, cubic kilometer, 1000cubic meter?, ..)?

closed as too broad by PolyGeo♦Mar 13 '17 at 5:39

Please edit the question to limit it to a specific problem with enough detail to identify an adequate answer. Avoid asking multiple distinct questions at once. See the How to Ask page for help clarifying this question. If this question can be reworded to fit the rules in the help center, please edit the question.

• What steps did you take to try to calculate the volume? – MaryBeth Dec 31 '15 at 19:38
• I create TIN from contours. And Raster from TIN for dam area. And on the other side create a TIN with Fixed elevation For example 150m In cut&fill order used them on before and after requirements – Amir Arsalan Dec 31 '15 at 21:16

Use a projected coordinate system suitable to your region. UTM is common for this. Those units appear to me to have been generated from:

x=decimal degree

y=decimal degree

z=your layer units such as meters.

So basically nonsense. Fractions of a degree / meter.

For this to make any sort of logic you need to:

1. Convert the all to the same units such as meter (x,y,z) and put 1 in the z-Factor.
2. Use actual units in x and y (not degrees) and then convert these units to 1 in the z units.

It is all here.

If the x,y units and z units are in different units of measure, the z-factor must be set to the appropriate factor, or the results will be incorrect. For example, if your z units are feet, and your x, y units are meters, you would use a z-factor of 0.3048 to convert your z units from feet to meters (1 foot = 0.3048 meter).

• Tanks for responding. I create a pline in Civil D 2015 and gave it elevation manually. Next I added it to GIS. I didn't change any unit setting and the coordinate unit is UTM. I used (0.3048) as Z factor and the same numbers that don't seem to be volume of a reservoir showed up. – Amir Arsalan Dec 31 '15 at 20:29
• Can you show me the screen capture in ArcCatalog that shows the coordinate is UTM and I should be able to help? I think it is not and Arc is viewing it as CGS 1983 – If you do not know- just GIS Dec 31 '15 at 20:32
• How can I Set my projected coordinate system on UTM? Would you mind tel me step by step? – Amir Arsalan Dec 31 '15 at 21:10