1

I’m working on a small project where I’m testing the ability of a laser to accurately measure the angle of a wire. My control for the experiment gives me X,Y,Z coordinates for a point on the wire and the laser gives a distance and a bearing to the point on the wire. Is there a simple calculation that I can do in excel that will transfer from distance (m) and bearing (deg).

  • 4
    This is a math problem (computational geometry) with no clear GIS component. – Vince Jan 14 '16 at 12:03
  • Thanks for the advice; have posted in another forum now also. – Rich Jan 14 '16 at 12:49
  • 3
    This is a measurement (geomatics) problem. I thought geomatics was On Topic! – Martin F Jan 15 '16 at 4:08
  • 1
    This question has been put on hold at math.stackexchange.com/questions/1612145/bearing-to-x-y-z, and had a migration from there to Mathematica rejected. Although it is not a "question about GIS", if it does not re-open at Mathematics then I think we should be sympathetic to it re-opening here because it is not far outside the scope of GIS and appears to be from a surveyor. – PolyGeo Jan 15 '16 at 6:09
3

Form (whole circle) bearing, zenith angle and horizontal distance to X, Y, Z

X = X0 + h_distance * sin(deg / 360 * pi()) Y = Y0 + h_distance * cos(deg / 360 * pi()) Z = Z0 + h_distance / tan(zenith / 360 * pi())

  • X0, Y0, Z0 are the coordinates of the station
  • deg / 360 * pi() changes angle from deg to radians

Horizontal distance from slope distance and zenith angle (deg)

h_distance = s_distance * sin(zenith / 360 * pi())

  • Thanks for the reply. In my set up I'm not recording a zenith angle, is there a way to do the calculation without? Rich – Rich Jan 14 '16 at 10:57
  • Only if you use the Z coordinate from the control, rearrange formula for Z to express zenith angle. This way you cannot control Z only X and Y. Other possibility if all the distances are in the same plane, you can use that plane as XY plane (e.g.zenith angle is 90 degree). – Zoltan Jan 14 '16 at 17:13

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.