0

This question already has an answer here:

I have several shapesfiles which perfectly overlay but the coordinates reference system is unknown. I need to overly these with other data in a different coordinate system. I tried initially to overlay with several projected and geographic coordinates systems associated with the area out of which two showed very close displacement (about 60m). Next i tried different datum with one of the 'promising' coordinates reference systems (a geographic coordinates system) and also changed the units but same results. Attached is a clip of one of the coordinate extents. I am yet to try the second 'promising' CRS but decided to put it out just in case i am missing something

marked as duplicate by PolyGeo Mar 21 '16 at 19:21

This question has been asked before and already has an answer. If those answers do not fully address your question, please ask a new question.

  • the coordinate extent is top 3576.5; left -0.5 ; bottom -0.5; right 2455.5. Another coordinate extent is ; top 3566.5; left -0.5 ; bottom 3.5 ; right 2455.5 and both overlay but CRS unknown – kofillartey Mar 21 '16 at 18:41
  • are they aligning in the correct geographical location in addition to aligning with themselves? – DPSSpatial Mar 21 '16 at 18:47
  • As I recently mentioned on the GeoNet version, those values look like ungeoreferenced rasters. Could the shapefiles have been converted from rasters? – mkennedy Mar 21 '16 at 21:25
1

In such cases I usually:

  1. Check X (Easting) and Y (Northing) coordinate values, they often indicate or provide some clues on which CRS they might be in. E.g. UTM X (Easting) coordinates will be typically 6 digits between +/- 200k and 700k, while Y (Northing) will depend on latitude (as they indicate distance from the Equator). Note also some local / national specific styles (e.g. adding UTM zone prefix to Easting in some German CRS).

  2. Check with Spatial Reference or similar source for all potential CRS for a given area.

  3. Prepare a sample reference dataset (e.g. boundaries, roads, rivers etc. depending on data) in a known coordinate system (e.g. WGS 84 - EPSG:4326).

  4. Try to assign different CRS definitions to my data and overlay with reference dataset. Note: pay attention to datum transformations, the displacement of 60 meters can easily be caused by wrong set of transformation parameters.

and finally (best option but often not available) - contact your data providers :)

Not the answer you're looking for? Browse other questions tagged or ask your own question.