2

i'm trying to display a polygon in qgis-2threejs which works fine. Now i want to adjust the height on the sides of the polygon, so that i can vary the body of the polygon.

Basically i want to display different fractures inside of a mountain with the height of each polygon adjusted to the surface.

See here:

enter image description here

4
  • 2
    Can't be done with polygons. It is 2.5D rather than 3D. Would have to be done as a raster DEM. Dec 9, 2016 at 9:12
  • ok, i see. but can i connect the DEM, which i assume to be just displaying the surface, to the bottom? So that it looks kinda like a polygon...?
    – Philipp B.
    Dec 9, 2016 at 9:48
  • The image on the right was made with QGIS2ThreeJS: 3.bp.blogspot.com/-pGzk4Dt5hlc/Uz8vpq9H2QI/AAAAAAAAAfw/… Dec 9, 2016 at 10:47
  • Ok, so i did the modelling with DEM´s and it worked like intended! Thanks!
    – Philipp B.
    Dec 12, 2016 at 14:17

2 Answers 2

3

As far as I know, it is not possible to get a sloped polygon in Qgis2treeJS.

However, you can create a second DEM with your mountain and display your lines on that surface.

You can then use your lines layer in Qgis2threeJS and select "profile" as object type. Then use the parameters Zcoordinate (mode absolute value, I'd recommend 0 ) and Height (the altitude of your layer) to draw a surface all the way through your model.

0

You need to set height according to your column and multiplier that column with your criteria. I did it with following way you can see screen shot of my process . this might help you enter image description here

1
  • 1
    I don´t want to change the height of the polygon, i want to change the heights of the corner-points in the polygon, so that i get a polygon with a slope...
    – Philipp B.
    Dec 9, 2016 at 8:53

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.