1

This is my first post so I'll try to be specific as possible but also as short as possible. I have created a "Bore Profile" jpg. In ArcMap, I brought into a feature class through labeling. I want to be able to pull attributes from the feature class to "fill in the blanks" on the bore profile sheet.

I am currently using ArcGIS 10.2.2.

Below is an image showing the bore profile that I created. The attributes that I want to fill in, inside ArcMap, are in red.

enter image description here

Below is an image of the bore profile as a label in ArcMap. I need to use Expression builder, or scripting, to pull in attributes to populate as shown above. Or, perhaps through a table?

enter image description here

Any ideas on how to do this would be great.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.