I am using ArcGIS Desktop 10.2.
I have created the origins points from a fishnet laid over my area of interest. Out of 1200, there are some 65 points for which the OD cost matrix cannot be calculated.
I have isolated these 65 points and tried to run the OD cost matrix only for them (just in case they were not computed because the matrix was too big), but to no avail. The warning is still displayed for all 65 locations. Eg: for location 1 "No destinations found for "location 1" in "origins"".
Any ideas on how to solve this problem?
Legend of Picture: yellow dots are those O that were successfully calculated, the orange are those that were not successfully calculated and the violet lines are each OD cost link.