1

Buffer on Lines not rounded on both ends

As you can see in the image, after using the 'Buffer' geoprocessing tool on ArcMap 10.2, the buffer is not symmetric in some cases, and is therefore flat on one end (as shown in the image). The Buffer setting I have used in the 'Buffer' settings is 'Rounded'.

The line layer I use to add buffer, is made by drawing lines between points using the 'Lines to Points' geoprocessing tool.

Thoughts?

closed as unclear what you're asking by PolyGeo Jul 13 '17 at 22:41

Please clarify your specific problem or add additional details to highlight exactly what you need. As it's currently written, it’s hard to tell exactly what you're asking. See the How to Ask page for help clarifying this question. If this question can be reworded to fit the rules in the help center, please edit the question.

  • 2
    The line might be bent back on itself so the start and end points may not actually be where you think they'd be – Midavalo Jul 12 '17 at 21:56
  • Interesting. Will check it out and let you know. – Prieston Lobo Jul 12 '17 at 22:13
  • Bend line still produces rounded buffer – FelixIP Jul 13 '17 at 0:16
  • @FelixIP is correct - I have been able to test now and found the buffers still produced fine with a line bent back on itself – Midavalo Jul 13 '17 at 4:06
  • What are the coordinates and coordinate system of that line? What are all of the parameter values that you used to perform the buffering? What were the precise steps that you used to run the Buffer tool i.e. where within the Geoprocessing framework did you run it? – PolyGeo Jul 13 '17 at 6:33