0

While performing raster calculator operation in ArcGIS for Advanced Vegetation Index ( in calculating forest canopy density), the results show only 2 values i.e high (1) and low ( 0), instead of a range of values.The low values considered are of that of the background no-data values.

What could be the possible problem in the operation ?

I am using the formula :

AVI = (("ref5"+1) * (256-"ref4") * ("ref5"-"ref4")) ^ (1/3)

where ref5, ref4 are bands 5, 4 corresponding to Landsat 8 image, converted into TOA reflectance values.

1 Answer 1

2

I think the equation in the raster calculator should be written as follows:

(("TOA_B5.tif"+1) * (256-"TOA_B4.tif") * ("TOA_B5.tif"-"TOA_B4.tif"))**(1.0/3.0)
  • **: means power
  • convert (1/3) integer division into float division (1.0/3.0)

You need to change "TOA_B5.tif" and "TOA_B4.tif" to the corresponding layer names exist in the table of content in ArcMap

6
  • I updated my answer, you need to remove AVI = in raster calculator. The above equation was tested and should be OK
    – ahmadhanb
    Feb 26, 2018 at 7:39
  • Hi. Thank you. Can you please tell me what formula have you used to get the TOA_B5 values ? Feb 26, 2018 at 8:27
  • 1
    @PrabhashiniMohapatra that is another question different from the one you asked. In GIS.SE, you can ask only one question at a time. If you have a new question, you need to write on a separate thread. Please prepare a detailed question of what have you tried and what formula you used when calculating the TOA.
    – ahmadhanb
    Feb 26, 2018 at 8:55
  • Hi. I tried this formula but I'm still getting the same results. Feb 27, 2018 at 6:23
  • What is the format of your raster data? I used tif as you can see in my answer.
    – ahmadhanb
    Feb 27, 2018 at 6:27

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.