0

I have a dataset of 70,000 points and I would like to interpolate the properties as a 3D raster. I have created 'slices' of properties each meter of elevation in the model domain; approx: 200 slices.

The format of the dataset is as follows: BH, EastingNad83, NorthingNad83, Elevation, Property(numerber),Property(text)

(coordinates are in UTM)
The data points are located along boreholes (approx 5000).

I am able to import the data set in Grass Gis. However, I am unable to create the 3D raster using V.Vol.Rst. Is the data set too large for this module?

  • Did you also set the 3rd dimension of the computational region with g.region (b - bottom and t - top parameters)? See grass.osgeo.org/grass74/manuals/… – markusN May 3 '18 at 6:04
  • I am wondering if as the data points are stacked above each other (vertical data set) then it just imports one layer (or elevation slice) – fanfanGis May 6 '18 at 15:54
0

it was an issue of g.region where you have to provide a value for the resolution for each parameter, and resolution should match if they are referring to the same direction.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.