I am using Sentinel-2 images and I want to clip the image with a shapefile I made. (The shapefile was smoothed with Smooth polygon with a 10m PAEK tolerance).
I have tried the Raster clip tool and the Image Analysis Toolbars with moderate success. I have gotten reasonable clips but the colors change, and I cannot access the attribute table.
How can I clip the raster without altering the way it look?
Because I will also be applying this method to 8A,11,5 composites.
RGB composite image and shapefile outline.
Raster clip (spatial analysis) and input parameters. Saved as a .tif and checked both boxes.
This is the result.
And when I used the Image Analysis Toolbar, I used the default parameters
And I got a result that is more or less the same. Some of the sources I have found say to clip each raster separately but when I tried, my result is still skewed.
Is it the statistics I need to recalculate?
How can I get clips to be the same as the original raster?
Or, is it OK for the values to be different?
I am going to apply a water mask and get the area of a plant that I am familiar with, the bright green seen in the photos.
This is the environment used