I am new to GIS and QGIS and I am going through the training manual. It says to "Open theQuery Builder by right-clicking on the all_terrain layer in the Layers panel, and selecting the Properties→Sourcetab."

This does not exist as far as I can tell in 3.6. No other posted questions have an answer. Help?

@ahmadhanb stated that I should do what is written out above. The problem I am facing is that this is what I get when I do as ahmadhanb suggests: screenshot

I am using windows 10 if that helps any.

  • What is the format of your data? Is it raster or vector? – ahmadhanb Mar 4 '19 at 18:59
  • Raster file. I am following the training manual in section 21.14.1. – Mark Mar 4 '19 at 19:02
  • I updated my answer. There is no Query Builder for raster data. The Query builder is only available for vector data. – ahmadhanb Mar 4 '19 at 19:04
  • @Mark can you provide a link to that training manual? – MrXsquared Mar 4 '19 at 19:06
  • 1
    The all_terrain layer the manual refers to here is a vector layer. As @ahmadhanb mentioned in his answer you will find the query builder for this. – MrXsquared Mar 4 '19 at 19:21

If the data is raster data, there is no Query builder for raster.

enter image description here

If the data is vector data, then right-click the layer in the table of contents -> Properties -> Source tab -> Query Builder at the lower right corner of the window:

enter image description here

  • I clarified my question by editing it. I am new to stack exchange so my apologies if this is not the right way to go about it. – Mark Mar 4 '19 at 18:55
  • @Mark If the answer solved your problem please accept it so that it will help others. – ahmadhanb Mar 5 '19 at 5:31

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.