4

I am trying to run a Iso-Area as Interpolation (from Point) calculation using QNEAT3 in QGIS 3.8.2.

To do so, I need to change the CRS from Geographic to Projected. I did that to my raster layer, but when I try to do the same to any of my vector layers, they just disappear.

I am trying to change it from EPSG:4326 - WGS 84, to EPSG:25832 - ETRS89 / UTM zone 32N.

5
  • 3
    Welcome to GIS:SE @WojtekAntoni! How did you change the CRS of your raster and vector layers?
    – Joseph
    Sep 5, 2019 at 12:53
  • thanks! right click on the layer in the toolbar -> set CRS -> set layer CRS. Then I searched for the one I needed and double clicked on that. Sep 5, 2019 at 13:00
  • 1
    For any kind of analysis, make sure to reproject it which saves the spatial data in the new CRS. For vectors, you can use the Reproject layer tool; for rasters, you can use the Warp (reproject) tool. Both of these are available from the Processing Toolbox.
    – Joseph
    Sep 5, 2019 at 13:05
  • 1
    It worked. Thanks a lot! Sep 5, 2019 at 13:42
  • Most welcome, glad it helped :)
    – Joseph
    Sep 5, 2019 at 14:02

1 Answer 1

3

For any kind of analysis, make sure to reproject it which saves the spatial data in the new CRS. For vectors, you can use the Reproject layer tool; for rasters, you can use the Warp (reproject) tool. Both of these are available from the Processing Toolbox. – Joseph

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.