3

I have a shapefile layer with a set of points.

enter image description here

I would like to enclose them (or turn them) into the polygon (with the line in the middle).

I tried this:

Converting cluster of Points to Polygons using QGIS?

Creating Minimum Convex Polygon - Home Range from Points in QGIS

which led me to the Convex Hull tool.

Unfortunately, it looks like, that this operation can be applied to the cluster of points instead of single located points.

enter image description here

|improve this question|||||
5

Instead of using the Convex hull tool, use the Minimum bounding geometry tool by specifying the desired type of geometry output as shown in the image below.

enter image description here

|improve this answer|||||
  • It appears to be valid, however once I set the minimum bounding geometry and selecting Node (one of the column apart from Lot & Lan) I am getting an empty layer. I found the similar issue here: gis.stackexchange.com/questions/283111/… which hasn't been resolved really. Any ideas about how to make the layer visible? – Mariusz Krukar Dec 23 '19 at 12:35
  • If I choose Convex hull, then I am getting: Feature could not be written to Bounding_geometry_40560c1f_a69b_4202_905d_4edcec325f04 – Mariusz Krukar Dec 23 '19 at 12:36
  • If the layer is not visible, there was an error during processing. Can you try with another layer of points ? – Vincent Bré Dec 23 '19 at 12:39
  • I have this one only populated so far. I can add it again. – Mariusz Krukar Dec 23 '19 at 12:58
  • Not needed mate. I found the mistake. I should have left the field point empty! Thank you for your help! – Mariusz Krukar Dec 23 '19 at 13:00

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.