I used SNAP sentinel 1 to calculate subsidence. After snaphu export I pen snaphu.conf and copy command as below then run it in Terminal I got The following error in picture:



Your windows command prompt does not recognize the snaphu command and does not know what to do when you enter snaphu. This can have two reasons:

  1. snaphu is not an official part of SNAP, you have to download it separately: https://step.esa.int/main/third-party-plugins-2/snaphu/ (at the bottom of the page, "Manual snaphu installation")

  2. You have to add the directory where snaphu.exe was downloaded to your system's path variable. An explanation is given here. Restart your command prompt and type snaphu again to check if it works. It should now show something like this: enter image description here If this is the case, you can run the snaphu command as created in the config file.

| improve this answer | |
  • Thank you so much for help> I installed the snaphu in SNAP as plugin , but I did not find snaphu.exe in my PC – user2726902 May 3 at 2:27
  • Downloading the plugin for SNAP is not enough, (this only creates an entry in the menu). You also have to install the bundles as described in this tutorial: step.esa.int/docs/tutorials/… You will be asked for download directory during this process. I still recommend to use snaphu from the command line. – AndyB May 3 at 8:03
  • Thank you so much – user2726902 May 3 at 17:00

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.