0

I’m a new user for the Water Geometric Network Editing and Analysis tool.

First, I am using ArcMap 10.8, and I built a geometry network as some online guides explain, although the process produced a 30-line error table for me, the net is as good as I checked. I've been trying to update the rules of the network, and I think that's fine too. But, when I get to run the tool options, like valves isolation, it didn't work at all. After searching the web and forums, I realized that I needed to configure the configuration file to fit the network I built, based on the entities I have.

After the configuration I did, things got better, he didn't throw an error message, but now he's running the tool, but nothing comes out.

From what I understand, I obviously have to define which layer is the valves, lines, etc.

Is there a way to do this without the configuration file?

I'm attaching the GDB with the layers and the network, the configuration file, and the error table.

1
  • As per the Tour there should be only one question asked per question. – PolyGeo Jun 15 '20 at 8:11

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.