0

I have no experience with topology validation in ArcGIS. I have polygon feature class.

When I create topology for this feature class, I specify two topology rules :

  • Must Not Overlap
  • Must Not have Gaps

After correcting all understandable artefacts, one problem remained visible on the map. I would like to ask you if I should to Mark as Exception?

enter image description here

  • 2
    Without access to the data, it would be very difficult to determine this. In the Error Inspector, what kind of error does it say this is? And is this picture the full extent of your data? – JoshC Oct 1 at 12:21
  • Yes the image represents whole my study area. The Error Inspector tool says a "Must Not Have Gaps" rule error. Is there any possibility to share the shapefile in the forum? – Tomek Bartuś Oct 1 at 16:07
  • This is all the more strange because the study area was previously clipped out from a larger area ... – Tomek Bartuś Oct 1 at 16:29
  • Is the study area itself a polygon in this file? Must Not Have Gaps flags lots of exceptions such as boundaries. – danak Oct 21 at 18:16
0

I can see you still have an error at the lower left side of your image, maybe this is the reason why the whole study area is highlighted as red:

enter image description here

| improve this answer | |
  • Yes..., I saw this error directly after I publicated my post. I corrected this artefact. Unfortunately topology still have one error in whole study area.... – Tomek Bartuś Oct 1 at 15:59

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.