Extract value to points runs but table won't open

Question

I am running ArcMap 10.4.

I have a point file and a raster and I am trying to run extract values to points. It runs successfully, but when I go to open the table I get this error:

Error reading OID from table. Reading rows has been stopped. Check that the datasource is valid.

I have done this in the past with no issues, I even tried it on a raster/point file that I have done the exact operation with before and get the same error. So I don't really think it's an issue with the data itself (although I'm sure it's possible).

Answer 1

1. Check by creating a new file geodatabase and creating a copy of feature classes
2. Check if you have any M value enabled on feature class, remove M/Z values and retry
3. If you are using a File geodatabase run the Check and repair geometry tool and retry your workflow. Check and Repair Geometry