0

I'm calculating partial TIN volumes using Polygon Volume in ArcMap 10.7. I've done this hundreds of times using arcpy and for the most part, it works fine (Height Field = MAX; Reference Plane = BELOW). However, sometimes the routine calculates a volume and a surface area of zero, respectively, without any error messages.
My data can be downloaded here. I have provided one example of a TIN and a shapefile that works, and one example of a combination that doesn't. I cannot figure out the difference between the two.

EDIT:
Following @Vince, I've used Check Geometry on the shapefile (as it does not work with TINs), which gave me the error notification:
Could not find spatial index.
When Repair Geometry did nothing to fix this, I simply ran Add spatial index.
After that, the Check Geometry routine gave me no further errors - however, I still get an area and volume of zero when I use Polygon Volume.

When I use other shapefiles (that overlap with the TIN to a larger or smaller extent) the volume/area calculation runs fine. So, I suspect the error has to lie within the shapefile - but I have no idea what caused it.

Improve this question
6
  • 1
    Try running Check Geometry and/or Repair Geometry to identify and correct topology errors. A "bowtie" (quadrilateral with 2nd and 3rd vertices swapped) will usually show zero area.
    – Vince
    Mar 25, 2021 at 12:07
  • Thanks very much for the info! Check geometry did indeed show some errors, but my problem is not solved. I've updated the question accordingly.
    – Florian Mlehliv
    Mar 25, 2021 at 12:33
  • 1
    @FlorianMlehliv, which column did you use as height? Your TIN has heights ranging from 2400-2250, but all the values from the table your are much lower. I did a test run, and it worked fine for me.
    – alecsx
    Mar 26, 2021 at 8:55
  • @alecsx: Thanks for the test run! I use the "MAX" column as height. But the height values for the shapefile ("MIN" and "MAX") are approximately in the same range as the TIN (2463-2243), so there should be no problem. Which column did you take when you succeeded with the test run?
    – Florian Mlehliv
    Mar 26, 2021 at 9:09
  • I used one of your hazard columns, and now I tried it with the MAX and it also works, just set your reference plane to BELOW, because if you set it ABOWE, you will get 0 values. desktop.arcgis.com/en/arcmap/10.3/tools/3d-analyst-toolbox/…
    – alecsx
    Mar 27, 2021 at 11:20

1 Answer 1

Reset to default
1

I was unable to find the reason for this not working for me but for others, however, this alternative should work:

Generate a copy of the TIN, edit this TIN with the polygon and then use Polygon Volume or Surface Volume.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.