3

I am using ArcMap 10.6 and ModelBuilder.

I have input points (LinepointS1) from a geometric network which contain sub 3000 points that I would like to trace downstream from and have the model spit out a shapefile which shows the start point/flag and downstream route and name the shapefile by an attribute from the linepoints1 i.e. an identifiable id.

I have managed to run the model so it'll create 1 shapefile with one point and downstream line and name it test.shp. The issue is that as it iterates for each of the 3000 points, the final output overwrites the previous point output.

enter image description here

How can I output different names with each pass?

Improve this question
2
  • 3
    You can likely just name your final output %Value%.shp.
    – lambertj
    Dec 20, 2022 at 16:22
  • @lambertj - thanks for this. this has now enabled the model to output the multiple shapefiles. wondering if there was a way to tell it to use a certain field in the LINEPOINTS1 table as it's name?
    – l-mog357
    Dec 22, 2022 at 13:47

0

Reset to default

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.