1

I have a lot of high resolution data from thin tracks on a diagonal.

Tiling these creates perhaps 80% or more completely blank tiles.

Is there a routine that can either tile an input raster without creating the blank tiles, or else remove the blank tiles from the resulting .vrt file (and delete the tile).

Improve this question
3
  • Can you add a screenshot showing the problem?
    – BERA
    Apr 26 at 16:42
  • Similar to this question? gis.stackexchange.com/q/446084/88814
    – Babel
    Apr 26 at 19:07
  • Cannot reply because I am not at work, but image you are scanning a road you have 1000 pixels covering 10m or so, and it streches for several kms. Most rasterisation routines create a rectangular image, but if your route goes at SW-NE nearly all of that rectangle is blank, with a thin strip of data going diagonally. I would like to tile it, but only have tiles at locations with actual data in them.
    – Campbell Smith
    Apr 26 at 19:33

0

Reset to default

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Browse other questions tagged or ask your own question.