Is it normal to use the geometry type 'multipoint' instead of 'point' knowing that I use it to store only one point?
How can I convert from multipoint to point?
-
There is a good answer that explains how to check for multi-part geometries and convert column types from multi- to single geometries at: gis.stackexchange.com/questions/28835/…– JohnCommented Apr 12, 2017 at 17:38
Add a comment
|
2 Answers
To convert "Multipoint" to "Point", you have to use ST_Dump, for example:
SELECT (ST_Dump(the_geom)).geom AS the_POINT_geom
FROM MULTIPOINT_table;
On the question of using "Multi" or single geometries, I use this logic:
- if every geometry has different attributes -> Single
- if a group of geometries have same attributes -> "Multi"
The easiest way to extract a point from a single-point MULTIPOINT is ST_GeometryN:
SELECT ST_AsText(ST_GeometryN('MULTIPOINT ((1 1))', 1));
--POINT(1 1)
This avoids potential problems in situations where a set-returning function cannot be used.
There are some important optimizations that are available only to POINT type geometries (especially in earlier versions of PostGIS), so storing single points as POINT is good practice. A POINT also uses about 25% less space than a MULTIPOINT.
