1

We are having problems with our representations when copying from an ArcGIS 9.3 database to a 10.0. Representation symbologies with dash patterns (dots, dotted lines etc.) are reset to default settings in the version 10.0 database.

The problem is the same when you copy from a 10.x to 10.x database.

Have anyone experienced the same, and what did you do to make it go away?

Improve this question

1 Answer 1

Reset to default
1

With this Question having attracted no Answers or Comments in about 18 months, if it is still causing you problems, then I think it will be best for you to contact Esri Support.

On the other hand, if you were able to resolve it by upgrading to a new version, or by any other means, then I recommend that you write that up as an Answer.

Improve this answer
3
  • I have contacted the support, and I have still not found a solution, so an answer would still be very helpfull. The problem is the same when you copy from a 10.x to 10.x database.
    – Morten
    Commented May 12, 2014 at 22:40
  • @Morten If Esri Support gave you an NIM number for this problem, which I think they should have, then can you record that in your Question, please?
    – PolyGeo ♦
    Commented May 12, 2014 at 23:03
  • i actually don't know, because i asked support unit of the the local Esri supplier. I think they forwarded the question to Esri, but I actually don't know.
    – Morten
    Commented May 13, 2014 at 11:13

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.